Yes, the Geratherm® non Contact can be switched between Celsius and Fahrenheit. Show Now switch the measurement scale between °C and °F by pressing the START button. Once you have selected the scale you want, wait 5 seconds for the thermometer to automatically switch to "Ready" mode for measurement. Yes, the battery of the Geratherm® non Contact can be changed. No, the Geratherm® non Contact is a non-contact thermometer. Use a sponge soaked in alcohol or a cotton cloth dampened with alcohol (e.g. 70% isopropanol) to clean the thermometer housing and the measuring sensor. No liquid should get inside the thermometer. Don't use aggressive ones Detergents, solvents or benzene for cleaning and never immerse the device in water or other cleaning liquids. The Geratherm® non Contact is not waterproof. The Geratherm® non Contact complies with IP 22 and is therefore protected against solid foreign objects with a diameter of 12.5 mm and more and against water dripping at an angle of up to 15 degrees. Observe the correct application according to the instructions for use. Measure again while observing the maximum distance to the forehead of 2 cm. For newborns under 6 months, carry out a control measurement with a conventional clinical thermometer.
IMPORTANT: BEFORE TAKING FIRST MEASUREMENTThe thermometer needs to acclimate to the ambient environment (temperature) in which measurements will occur. It is important to allow the JXB-178 to acclimate to the room temperature for at least 15 to 20 minutes prior to first using the thermometer. Subsequent usage – each time there is a significant change in the ambient temperature due to a change in the environment, allow the JXB-178 to acclimate to this ambient temperature for at least 15 minutes prior to using it. CHANGING TEMPERATURE MODEWhile the thermometer is turned on, press the MODE button to toggle through the three temperature mode options: BODY, SURFACE or ROOM. NOTE: When first using the thermometer, the default is set to BODY mode. NOTE: Measurement ranges for each temperature mode are as follows: BODY mode: 89.6°F to 109°F (32°C to 42.9°C) SURFACE mode: 32°F to 140°F (0°C to 60°C) ROOM mode: 50°F to 104°F (10°C to 40°C) NOTE: Once the thermometer is powered on, the last temperature mode measured will default as the current temperature mode. NOTE: Always use the BODY mode to measure internal human temperature. CHANGING TEMPERATURE UNITWhile the thermometer is turned on, press the MODE button for 2 seconds, screen will display “F1”, then press the MODE button to transfer between degree Celsius and Fahrenheit, confirm by pressing the MEM button. TAKING A MEASUREMENT
 Note: High temperature alarm default setting is 100.4˚F (38˚C). LOW BATTERY DETECTIONIf the battery voltage is not more than 2.7V, the JXB-178 Non-contact Infrared Thermometer will display the flashed symbol CHANGING THE BATTERIESThe JXB-178 Non-contact Infrared Thermometer requires 2 AA alkaline batteries. When the LCD screen displays TROUBLESHOOTINGDocuments / ResourcesHow do you change C to F on non contact infrared thermometer?How to change from F° to C°. Firstly ensure the thermometer is turned on, you can do this by pressing the trigger (power button). ... . Press and hold the 'Set' button until you see the screen flash 'F1' then 'Unit'. In the top right corner, you will see either °F or °C flashing.. |
Non contact infrared thermometer how to change to fahrenheit
Related Posts
Copyright © 2024 muatrau Inc.
