How to reset change transmission fluid on chevy captiva

Reputation: 0

Thanks Given: 5
Thanks Received: 4 (3 Posts)

Posts:  41  Threads:  13
Joined: Dec 2015

1 03-12-2017, 03:10 AM

Good afternoon,

2013 chevy captiva sport ls

on the dash display have message to change trans fluid. Service was perfomed. Cant figure out how to reset the message. tried thru the display buttons. tried koeo press gas 3 times. Also tried snap on scanner- no option avail.

Thanks given by:

Tek1229  

Reputation: 90

Thanks Given: 70
Thanks Received: 304 (128 Posts)

Posts:  303  Threads:  5
Joined: May 2011

2 03-13-2017, 06:10 PM

pull the ipc fuse for 2 minutes..

Thanks given by:

waybux  

Reputation: 0

Thanks Given: 5
Thanks Received: 4 (3 Posts)

Posts:  41  Threads:  13
Joined: Dec 2015

3 03-13-2017, 08:09 PM

(03-13-2017, 06:10 PM)Tek1229 Wrote: pull the ipc fuse for 2 minutes..

ok. I will try when vehicle returns. I really appreciate your time.

Thanks given by:

Tek1229  

Reputation: 90

Thanks Given: 70
Thanks Received: 304 (128 Posts)

Posts:  303  Threads:  5
Joined: May 2011

4 03-13-2017, 08:45 PM (This post was last modified: 03-13-2017, 09:07 PM by Tek1229.)

Good luck, that should do it, I tried finding it in print again in SI, there's a typo in SI where it says to reset the change timing belt light you need to pull the fuse for 2 minutes but the funny part is that you find that in the transmission section... Totally screws with the search function, think I had to call tac with my first one..

Edited to add:
found this in transmission section..
The Instrument Cluster monitors the odometer mileage to determine when timing belt (if equipped) replacement may be necessary. After the vehicle has accumulated approximately 100,000 miles (160,000 kilometers), the Instrument Cluster may display the CHANGE TIMING BELT message. After the engine timing belt has been replaced, reset the CHANGE TIMING BELT message by locating and removing the fuses that supply power to the Instrument Cluster for two minutes

Found this under ECM replacement..
Transmission Fluid Life Remaining—When available, use the scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was replaced.

Thanks given by:

waybux  

Reputation: 0

Thanks Given: 5
Thanks Received: 4 (3 Posts)

Posts:  41  Threads:  13
Joined: Dec 2015

5 03-14-2017, 01:04 AM (This post was last modified: 03-14-2017, 01:09 AM by waybux.)

Great. Still don't have the car yet, but I did find this info following what you said.

Alldata states IPC fuse is underhood and fuse 10.

Mitchell shows this diagram[/quote]

Thanks given by:

How do I reset my transmission fluid?

How many quarts of transmission fluid does a Chevy Captiva take?

How do you check the transmission fluid on a Captiva?